- Joined
- Jun 14, 2017
- Messages
- 158
- Motherboard
- Asus X299 Prime Deluxe
- CPU
- i9-7900X
- Graphics
- Vega & RTX 2080 Ti
1.) Unfortunately, the 34wk95u-w does not support Titan Ridge capabilities and therefore only can be used as an end point TB device, no daisy chaining and therefore also no second TB port on the monitor.
2.) To know how to successfully drive the monitor at full resolution under macOS via DP1.4 see e.g. post #11097, #11099.
3.) TB3 Tests with the GC-Titan Ridge should have been kicked-off by 9th November 2018, see post #11270.
If you do not succeed, I am sure @flymovies can help..
Good luck,
KGP
I am back! Sorry it took a while, but I was on a business trip and will only have a few hour at home, before. I have to go on travels again until Monday.
However @kgp, good news! The CG Titan Ridge has arrived and is installed in Slot 4. It is properly connected (without USB header though for now) and it has been activated in the BIOS.
I have attached my EFI folder - please don't judge me on the DSDT.aml implementations (I did not do them) and the folder structure itself - it will be certainly full of errors, which is why I would need your help please to get this structured so I can get the CG Titan Ridge working and tell you guys about compatibility with the LG 5k2k screen running on TB3.
Note the serial numbers have been removed from the configuration and it contains a fresh DSDT.aml dump (F4) from Clover.