- Joined
- Aug 13, 2010
- Messages
- 417
- Motherboard
- Gigabyte GA-X58A-UD3R
- CPU
- X5650
- Graphics
- HD 7970
- Mac
- Mobile Phone
[SOLVED] Help, keep getting stuck on first reboot after install
Having trouble with first boot after update.
I cloned my Mavericks system so I could test, followed the instructions from the first page, booted using -v, installed Yosemeti over Mavericks. Successful install, boot again from the USB - but cannot boot into Yosemti to run Multibeast. The farthest I have gotten is by using kext-dev-mode=1 -v (and various other flags), it stops at several points, kernel panics or shuts off. I am installing on a partition of one of my disks. Do I need to use a full disk to text? I have a successful clean install on another disk. Do I need to install Chimera to the test disk?
Or what am I doing wrong?
Having trouble with first boot after update.
I cloned my Mavericks system so I could test, followed the instructions from the first page, booted using -v, installed Yosemeti over Mavericks. Successful install, boot again from the USB - but cannot boot into Yosemti to run Multibeast. The farthest I have gotten is by using kext-dev-mode=1 -v (and various other flags), it stops at several points, kernel panics or shuts off. I am installing on a partition of one of my disks. Do I need to use a full disk to text? I have a successful clean install on another disk. Do I need to install Chimera to the test disk?
Or what am I doing wrong?