HELP installing Monterey on Dell Optiplex 3070 Micro

[Feartech]

Hi I Did all the steps
Not sure of XCHIPortlimit where to find it
I booted again and same error

Please check the modified EFI

made all the changes you suggested XCHIPortlimit unable to find Please help

you will find XCHIPortlimit in your config.plist, it needs to be set to disabled

 

[billaq]

I followed and corrected each step now i am on different error and stuck

 

[Feartech]

I followed and corrected each step now i am on different error and stuck

you forgot to attach your zipped EFI

 

[billaq]

Here you go the latest one

 

[Feartech]

Here you go the latest one

your opencanopy.efi is older than your other files, update that with newer file

may or may not need:
SSDT-PMC.aml

disable:
XHCI-unsupported.kext
USBInjectAll.kext
to test

 

[billaq]

Uodated Canopy
SSDT PMC Disabled
XHCI-unsupported.kext
USBInjectAll.kext
disabled

 

[billaq]

possible we can connect via zoom or gmeet?

 

[Feartech]

possible we can connect via zoom or gmeet?

no, go back and read the rules

 

[Feartech]

Uodated Canopy
SSDT PMC Disabled
XHCI-unsupported.kext
USBInjectAll.kext
disabled

check bios settings:
Disable:
Fast Boot
Secure Boot
Serial/COM Port
Parallel Port
VT-d (can be enabled if you set DisableIoMapper to YES)
CSM
Thunderbolt(For initial install, as Thunderbolt can cause issues if not setup correctly)
Intel SGX
Intel Platform Trust
CFG Lock (MSR 0xE2 write protection)(This must be off, if you can't find the option then enable AppleXcpmCfgLock under Kernel -> Quirks. Your hack will not boot with CFG-Lock enabled)

Enable:
VT-x
Above 4G decoding
Hyper-Threading
Execute Disable Bit
EHCI/XHCI Hand-off
OS type: Windows 8.1/10 UEFI Mode
DVMT Pre-Allocated(iGPU Memory): 64MB or 128MB
SATA Mode: AHCI

tell me which ones you can enable/disable

 

[billaq]

General → Advanced Boot Options: uncheck System Configuration → SATA Operation: AHCI Secure Boot → Secure Boot Enable: Disabled Intel® Software Guard Extensions™ → Intel® SGX™ Enable: Disabled Power Management → Block Sleep: check Virtualization Support → VT for Direct I/O: uncheck
Only these bios settings are available