RehabMan
Moderator
- Joined
- May 2, 2012
- Messages
- 181,015
- Motherboard
- Intel DH67BL
- CPU
- i7-2600K
- Graphics
- HD 3000
- Mac
- Mobile Phone
here I done clover like in ur guide and same not booting I try your clover r4061 and its same not booting properly can look now maybe? now I booted only from usb and same with drop oem
No verbose boot photo attached.
What is the difference between this EFI/Clover and the one you booted with when you collected the ioreg provided in post #2223?
Because your Clover bootlog (extracted from ioreg) shows SSDTs loading as expected, and clearly that setup worked just fine...
Code:
18:162 0:000 Start: Processing Patched AML(s): Sorted
18:162 0:000 Inserting table[0]:SSDT.aml from EFI\CLOVER\ACPI\patched ... Success
18:163 0:001 Inserting table[1]:SSDT-0.aml from EFI\CLOVER\ACPI\patched ... Success
18:164 0:001 Inserting table[2]:SSDT-1.aml from EFI\CLOVER\ACPI\patched ... Success
18:165 0:001 Inserting table[3]:SSDT-2.aml from EFI\CLOVER\ACPI\patched ... Success
18:165 0:000 Inserting table[4]:SSDT-3.aml from EFI\CLOVER\ACPI\patched ... Success
18:166 0:000 Inserting table[5]:SSDT-4.aml from EFI\CLOVER\ACPI\patched ... Success
18:166 0:000 Inserting table[6]:SSDT-12.aml from EFI\CLOVER\ACPI\patched ... Success
18:166 0:000 Inserting table[7]:SSDT-13.aml from EFI\CLOVER\ACPI\patched ... Success
You should start with unmodified native DSDT + SSDTs in ACPI/patched.
Verify you can boot that way...
Then apply patches one at a time until you determine the cause of the problem.
For you to investigate.
Note: Your FakeSMC.kext is not per guide. Also, config.plist/SMBIOS/Trust should be true. Also, use MacBookPro11,1, since you don't have the correct patches for HWP.