RehabMan
Moderator
- Joined
- May 2, 2012
- Messages
- 181,016
- Motherboard
- Intel DH67BL
- CPU
- i7-2600K
- Graphics
- HD 3000
- Mac
- Mobile Phone
I'm stuck at the based DSDT patching section, never done that before. (I've built desktops and 4530s's, so it was simpler).
ACPI patching guide: http://www.tonymacx86.com/el-capitan-laptop-support/152573-guide-patching-laptop-dsdt-ssdts.html
My initial problem is whilst using your config.plist, it opens in clover editor without the disabled lines you described.
If I click on "Kernel and Kext patches", 7 KetsToPatch appear, but only "disabled:IOGraphics" appears disabled.
There is a config.plist attached to post #1.
You should use a plist editor to edit config.plist (Xcode or PlistEdit Pro).
Can you point me at any guides on how to use clover configurator to create the base DSDT patches you describe ? Not quite sure how it works.
Post #1 "base DSDT" patches are done with MaciASL, not Clover Configurator.