Graphics
- Boot-arg darkwake=8 is the same as darkwake=0...
Other Observations
- You may need to enable CLOVER's ACPI->SSDT->Generate->PluginType for power management...
Good morning, I have tested the changes you mentioned in your message except the one that says "Your ACPI-> Patched includes SSDT-PMC. I think you also need to define Device (PPMC) for the full PMC implementation" which is above my knowledge.
The first thing I have noticed is that macOS starts up a little faster (before, it started up quite fast but now it has gained a few seconds), I think that it is most likely because I have selected the PluginType option.
Regarding the integrated graphics, it works well (as before) but now it comes out of sleep and shows the desktop ... to immediately restart the system. Before, it always got to black screen after coming out of sleep but it did not restart.
The changes have been:
- only 2 boot-arg: darkwake = 2 and igfxonln = 1 (I have also tried darkwake = 3)
- remove framebuffer-unifiedmem, framebuffer-stolenmem and framebuffer-fbmem
- change to native device-id 0x3e91
- and PluginType enabled.
One question: framebuffer-conX-flags C7030000 has to be added in reverse byte order mode or as is?
Thank you!!! Regards.