RehabMan
Moderator
- Joined
- May 2, 2012
- Messages
- 181,016
- Motherboard
- Intel DH67BL
- CPU
- i7-2600K
- Graphics
- HD 3000
- Mac
- Mobile Phone
Hi @RehabMan
I spoke with you yesterday re my system and following that discussion decided to install 10.13.2 which I have now done (HFS-J)
I would like to get USB working correctly but I would need help if you are prepared to do that. The guides are above my level of understanding, so I hope you will indulge me, I can follow instructions accurately and I have rudimentary knowledge, willing to learn.
I have set in BIOS XHCI mode to enabled as suggested.
Re port discovery, I went through this previously when you helped me with an injector Kext (For El Capitan). I identified the ports as below
View attachment 307582
I may be asking a stupid question, but I identified these I believe when on EHC so do I need to do the whole thing again while on XHC? Hope that makes sense
EDIT, ATTACHED FILES
Your ioreg shows that you forgot to use the port limit patch.
As per post #1, you must use the port limit patch during port discovery as without it, you will not be able to accurately record the ports which are used.