- Joined
- May 10, 2014
- Messages
- 45
- Motherboard
- Gigabyte z170x UD5 TH
- CPU
- 6700K
- Graphics
- 980 ti
- Mac
hahaha - just tried to reboot and guess what now getting pages error after doing nothing.
Have you looked at:
Skylake Starter Guide:
Are you booting with nv_disable=1 with card installed?Ok so i have to say close to throwing in the towel here
tried all usb ports
tried most of the guides
tried multiple USB sticks
and you know the worst thing is that when tried all the ports in sequence then on two attempts the boot got further without any changes to switches
On this board z170 premium by Asus take top USB c as 1 then if you do that and work right and down then usb ports 4 and 7 worked once, well moved us forwards.
7 did the best but failed with ATHR :21
Tried to boot again not touched anything and then it didnt work at all - just paging errors
Please could someone help me - really would be appreciated.
Are you booting with nv_disable=1 with card installed?
Try checking FixOwnership in Devices/USB in clover configurator.
I would check what Clover version you're booting with. Look on the EFI partition of your USB drive at EFI/Clover_Install_Log.txt and see what "Installer version" it says in the first few lines.
Also, if you want all your USB ports to work as expected, you should apply at least the initial USB fix from the Skylake Starter Guide. That might help distinguish between the USB port/drive combo not working and any other issue.
I would check what Clover version you're booting with. Look on the EFI partition of your USB drive at EFI/Clover_Install_Log.txt and see what "Installer version" it says in the first few lines.
Also, if you want all your USB ports to work as expected, you should apply at least the initial USB fix from the Skylake Starter Guide. That might help distinguish between the USB port/drive combo not working and any other issue.