- Joined
- Aug 20, 2018
- Messages
- 26
- Motherboard
- Dell Latitude 5290 2-in1
- CPU
- i5 8350u
- Graphics
- UHD 630
Hi!
Most of the issues have been patched on Dell Latitude 5290 2-in-1 except for the following:
- Sleep
- Trackpad works as up to 2 point gesture mouse (It will not be easy to patch)
- Touchscreen
- Brightness Reset
- Fn key
- Physical volume key sensitivity
- 2 Pcie camera (It will not be easy to patch)
- Wireless (have to replace)
There's a problem with the simultaneous use of the touchscreen and trackpad.
With the currently installed VoodooI2C.kext, VoodooPS2Controller.kext, the trackpad can be recognized as a mouse and used. (not bad. it works without VoodooI2C)
When VoodooI2CHID.kext is added, the touchscreen display is recognized as Magic Trackpad 2 and all gestures are enabled, but the trackpad (mouse) is disabled and can't used.
(Touchscreen works only when VooodooI2C and VoodooI2CHID are used together.)
I want to activate and use touchscreen, trackpad (mouse) together.
What should I do?
** All kexts are unchanged plist.
** VoodooI2CSynaptics.kext was added because of its sensitivity when using touch screen.
** If I add DSDT 'GPIO Controller Enable [SKL +]' patch, even if I delete all voodoo kext, only the touch screen will be recognized as Magic Trackpad 2.
** My trackpad(works as mouse) is on the 'Dell Travel Keyboard'.
Attached 2 PR, one is to exclude VoodooI2CHID(trackpad works as mouse), the other is to add VoodooI2CHID(touchsceen works as Magic Trackpad 2)
Most of the issues have been patched on Dell Latitude 5290 2-in-1 except for the following:
- Sleep
- Trackpad works as up to 2 point gesture mouse (It will not be easy to patch)
- Touchscreen
- Brightness Reset
- Fn key
- Physical volume key sensitivity
- 2 Pcie camera (It will not be easy to patch)
- Wireless (have to replace)
There's a problem with the simultaneous use of the touchscreen and trackpad.
With the currently installed VoodooI2C.kext, VoodooPS2Controller.kext, the trackpad can be recognized as a mouse and used. (not bad. it works without VoodooI2C)
When VoodooI2CHID.kext is added, the touchscreen display is recognized as Magic Trackpad 2 and all gestures are enabled, but the trackpad (mouse) is disabled and can't used.
(Touchscreen works only when VooodooI2C and VoodooI2CHID are used together.)
I want to activate and use touchscreen, trackpad (mouse) together.
What should I do?
** All kexts are unchanged plist.
** VoodooI2CSynaptics.kext was added because of its sensitivity when using touch screen.
** If I add DSDT 'GPIO Controller Enable [SKL +]' patch, even if I delete all voodoo kext, only the touch screen will be recognized as Magic Trackpad 2.
** My trackpad(works as mouse) is on the 'Dell Travel Keyboard'.
Attached 2 PR, one is to exclude VoodooI2CHID(trackpad works as mouse), the other is to add VoodooI2CHID(touchsceen works as Magic Trackpad 2)
Attachments
Last edited: