Clover update stopped working system

[GreyWolfRon]

This is the NIC I installed

 

[GreyWolfRon]

Disregard what I said about the broadcom chip. I just took the motherboard out and see that I took out the onboard WiFi completely out of its carrier and used the Fenvi board. So I guess that the Intel i210 is what I have but I am looking.

 

[GreyWolfRon]

Here is what the lan is

 

[GreyWolfRon]

Since I have the Fenvi board. What kext to I use? The guide says "non-Apple/non-Fenvi"

 

[GreyWolfRon]

don't forget an ethernet kext

These are the Kexts I have in the OC>Kexts.

 

[Feartech]

These are the Kexts I have in the OC>Kexts.

View attachment 575793

you can remove that IntelSnowMausi.kext

your wifi may be support already without a kext

 

[GreyWolfRon]

you can remove that IntelSnowMausi.kext

your wifi may be support already without a kext

I will do that. Here is what the config looks like.

 

[GreyWolfRon]

you can remove that IntelSnowMausi.kext

your wifi may be support already without a kext

This is where I am getting lost. After I mount the EFI, this is what I get. No files.

 

[GreyWolfRon]

you can remove that IntelSnowMausi.kext

your wifi may be support already without a kext

So I copied the EFI folder from my desktop into the EFI partition. Hope this is correct.

 

[GreyWolfRon]

you can remove that IntelSnowMausi.kext

your wifi may be support already without a kext

I hate to be such a pain, but I boot from the usb and I get this.