- Joined
- Jan 29, 2013
- Messages
- 734
- Motherboard
- Gigabyte Z390 Aorus Pro Wifi
- CPU
- I7-9700K
- Graphics
- NITRO+ RX 5700 XT
- Mac
- Mobile Phone
8.18.29 obtained from apple
Ill try yours now cheers
Ill try yours now cheers
Your patch still works with 10.9.2, it's lucky that you use {} bit mask instead of real values.Ah strange... But yeah this solution is even better for Clover, since you can have different patches for different resolutions... My patch was to make one universal kext, but that is not relevant for Clover.
Thx for the heads up, I knew there was a change from 10.8.5 -> 10.9, but didn't know about the 10.9.1 -> 10.9.2. I will check later, because I am a bit curious what Apple changed.
Is your display low-res?same result, vanilla kext, no patch added to clover, HDMI including audio works (display port if that makes any difference)
Well, that was my goal, I spend a few hours around perl forums to figure that command out. So was a bit more then luck .Your patch still works with 10.9.2, it's lucky that you use {} bit mask instead of real values.
Nice work, BTW i was talking about your tool not about this patches in that instance .It's mine
I will test it tomorrow and report my result.
Then as i said in my previous post you do not need any patches, since you have a DP connector and use the 03 port configuration table.
Then as i said in my previous post you do not need any patches, since you have a DP connector and use the 03 port configuration table.
Well, idk about that, but on the plus side you can use 2560 by 1440 pixels displays. Personally I find that way more important.ok, bonus for me then lol (apart from the fact DP is poo compared to HDMI in regards to max cable lengths, and needing to under scan on a 1080p screen boo!! )
cheers