Contribute
Register

Clover Legacy stuck on b1f: init5

Status
Not open for further replies.
Agnihotri said:
this is New image so i have to convert particular partition or entire DISK.
Click to expand...

Partitioning style applies to the disk, not to individual partitions. If you think about what partitioning is, that much is obvious...
 
you can try gparted.... is more friendly.... use msdos partitioning table but GPT is recommended...

or you can use a windows iso....
press SHIFT+F10 at installation prompt appears

1- type diskpart
2- type disklist (your hdd should be 0)
3- select disk 0
4- clean (all data will destroyed)
5- create partition primary
6- convert GPT and reboot
7- install osx
8- after installation boot with the installation media of mac
9- then install clover unchecking uefi only

you should boot correctly....
 
Last edited:
MarcoMjet said:
you can try gparted.... is more friendly.... use msdos partitioning table but GPT is recommended...

or you can use a windows iso....
press SHIFT+F10 at installation prompt appears

1- type diskpart
2- type disklist (your hdd should be 0)
3- select disk 0
4- clean (all data will destroyed)
5- create partition primary
6- convert GPT
7- install osx
8- after installation boot with the installation media of mac
9- then install clover unchecking uefi only

you should boot correctly....
Click to expand...
i don't get it clearly ..i have to install windows again in HDD and use these steps
 
no u have only to boot with windows installation media....
 
manuelleken said:
Disabling USB 3.0 in BIOS fixed the "stuck at b1f: init5" for me ;-)
Click to expand...
I don't have USB3 port..only USB 2 I have a old bios Laptop ... I m trying to convert in GPT using WindowsUSB but I am Stück at "Create Partition Parimary" how I create Partition BEFORE converting in GPT.
Can I first convert in GPT my disk 0 then partition
 
Last edited:
Agnihotri said:
I don't have USB3 port..only USB 2 I have a old bios Laptop ... I m trying to convert in GPT using WindowsUSB but I am Stück at "Create Partition Parimary" how I create Partition BEFORE converting in GPT.
Can I first convert in GPT my disk 0 then partition
Click to expand...

What are you trying to do? Have you already installed? Or are you still trying to boot the installation USB?
 
Now
RehabMan said:
What are you trying to do? Have you already installed? Or are you still trying to boot the installation USB?
Click to expand...
I m trying to convert my HDD in GPT scheme through windowsUSB installer using diskpart command but I m confused how I create partition primary then convert in GPT scheme to remove b1f:init 5 error.
I am using manuelleken solution
 
Status
Not open for further replies.
Copyright © 2010 - 2024 tonymacx86 LLC
Back
Top