Can't install fresh ML on Asrock z68 pro3

[eyax]

Hi,
This is my first time i'm trying to create an hackintosh but i'm stuck in the logo screen.
my hardware is:
mobo: asrock z68 pro3
cpu: i7 2600k
gpu: nvidia gtx 470
8 gig ram

I also tried to use these parameters:
GraphicsEnabler=No PCIRootUID=0 npci=0x2000
GraphicsEnabler=No PCIRootUID=0 npci=0x3000
nv_disable=1
-x GraphicsEnabler=No PCIRootUID=0

but nothing is work for me and i can't get into the installation screen.
my comp is always booting up then show me over and over the usb option with tonymac logo.

please help,
Thanks

 

[MiniITX]

Make sure you flash the BIOS with the modded BIOS rom > http://biosrepo.wordpress.com/asrock/z68/

More info about modded BIOS > http://www.tonymacx86.com/dsdt/47397-msi-asrock-foxconn-1155-patched-bios-thread.html

Set the BIOS as per below.

Advance > Advanced\North Bridge Configuration
Primary Graphics Adapter > PCI *
Share Memory > 64MB*
Render Standby > Disabled*

Advanced\South Bridge configuration
Deep Sleep > Enabled in S5*

Advanced Storage Configuration
SATA Mode > AHCI*
Hard disk SMART > Enabled*

ADvanced\Super IO config > Serial Port - Disable

Advanced ACPI conf
Suspend to RAM > Disabled*
ACPI HPET Table > Enabled*
RTC Alarm power on > by OS*
reset of the option here is disabled.

Not so imp settings but runs the system quite. Once you boot in fans are controlled by OSX.
HW Monitor
CPU FAN > Level 2
Chassis fan settings > Level 4

Install OSX using Unibest for ML. > http://www.tonymacx86.com/61-unibeast-install-os-x-mountain-lion-any-supported-intel-based-pc.html

Download multibeast for mountain lion and make sure you install correct kexts.

 

[eyax]

Hi,
some more question before i begin:
1.Does this configuration will work with windows also?
2.in some post i read something about sleep that doesn't work, is this configuration will fix the sleep problem?

Thanks a lot.

 

[MiniITX]

1.Does this configuration will work with windows also?

No

2.in some post i read something about sleep that doesn't work, is this configuration will fix the sleep problem?

For sleep to work on ASRock motherboards you will need a DSDT with correct edits.

 

[eyax]

The windows os will not work because od the bios settings or because of the patch?
if it's because the settings ( AHCI etc... ) then it's not a problem,i can keep 2 settings in my bios.
but if it's because of the patch then i'm in a big problem.

Thanks

 

[samisnake]

it wont be because of the bios.
if you didnt install windows with ahci mode enabled, you cant boot windows with ahci mode enabled, until you do a registry edit.

http://www.sevenforums.com/tutorials/61869-ahci-enable-windows-7-vista.html