- Joined
- Dec 20, 2016
- Messages
- 16
- Motherboard
- Asus ROG Z390 H GAMING-Clover
- CPU
- i9-9900K
- Graphics
- RX 580
- Mac
I attempted to update to 10.2.2. I am now getting the black screen caused by the fact that my mac is set to 6,1. I cloned my system to another drive and can boot from there on 10.2.1, but I just purchased some software that requires the update to 10.2.2 to run.
I attempted to run the fix for it, but received a message that I had to disable the SIP - side question - I assume the osX update reenables this by default? I definitely did not reenable it myself.
So I went to boot the recovery hd so i could run the terminal command to disable SIP, but it will not boot. It gets the apple logo and the loading bar goes up to maybe about 2/3 of the way and then just freezes and does nothing. Once it gets to about half way up, it starts to move extremely slow before stalling out.
I also attempted to boot from my usb boot stick and got the same exact result. Then i even tried to recreate the boot stick from scratch using unibeast just to see if that might have cleared something up, but no luck.
Any insight is greatly appreciated!
I attempted to run the fix for it, but received a message that I had to disable the SIP - side question - I assume the osX update reenables this by default? I definitely did not reenable it myself.
So I went to boot the recovery hd so i could run the terminal command to disable SIP, but it will not boot. It gets the apple logo and the loading bar goes up to maybe about 2/3 of the way and then just freezes and does nothing. Once it gets to about half way up, it starts to move extremely slow before stalling out.
I also attempted to boot from my usb boot stick and got the same exact result. Then i even tried to recreate the boot stick from scratch using unibeast just to see if that might have cleared something up, but no luck.
Any insight is greatly appreciated!