- Joined
- Feb 5, 2011
- Messages
- 15
- Motherboard
- GA-Z68x-UD4 B3
- CPU
- Intel i7 2600k
- Graphics
- GTX 660 2 Gb
- Mac
- Classic Mac
- Mobile Phone
Hi guys. I have my almost...fully working Hackintosh with El Capitan 10.11.2 (i have fear of upgrade to 10.11.3).
https://onedrive.live.com/redir?res...authkey=!ANzY_5Qd1mwVOJU&v=3&ithint=photo,jpg
I have this error randomly. I can power on my Hack 10 times and it run at first time or give me this error 5 times in a row. When Hackintosh starts all work fine, but i want to repair this problem to start my computer without error.
I check http://www.tonymacx86.com/el-capita...st-solutions-el-capitan-install-problems.html and I see:
Boot fails with Error allocating 0x#### pages at 0x####... alloc type 2
If it next says Error loading kernel cache then you most likely have SIP enabled and it can't generate a kext cache
Figure out which config.plist you're using, and check it for the RtVariables needed to disable SIP for El Capitan (covered in this guide)
If that's not it, try using a different USB port for the install drive (front/back, USB2/USB3, etc.)
If that's not it, try replaced VBoxHfs.efi with HFSPlus.efi in EFI/CLOVER/drivers64UEFI/
I have in my config.plist in RT Variables:
- Booter config: 0x28
- CsrActiveConfig: 0x67
I use SSDT from Multibeast (Sandy Bridge) and in ACPI i have all unchecked. I havent DSDT of my Motherboard.
I try to replace VBoxHFS.EFI and KP...need to change booting with USB.
Any idea? please!!
Thank so much
https://onedrive.live.com/redir?res...authkey=!ANzY_5Qd1mwVOJU&v=3&ithint=photo,jpg
I have this error randomly. I can power on my Hack 10 times and it run at first time or give me this error 5 times in a row. When Hackintosh starts all work fine, but i want to repair this problem to start my computer without error.
I check http://www.tonymacx86.com/el-capita...st-solutions-el-capitan-install-problems.html and I see:
Boot fails with Error allocating 0x#### pages at 0x####... alloc type 2
If it next says Error loading kernel cache then you most likely have SIP enabled and it can't generate a kext cache
Figure out which config.plist you're using, and check it for the RtVariables needed to disable SIP for El Capitan (covered in this guide)
If that's not it, try using a different USB port for the install drive (front/back, USB2/USB3, etc.)
If that's not it, try replaced VBoxHfs.efi with HFSPlus.efi in EFI/CLOVER/drivers64UEFI/
I have in my config.plist in RT Variables:
- Booter config: 0x28
- CsrActiveConfig: 0x67
I use SSDT from Multibeast (Sandy Bridge) and in ACPI i have all unchecked. I havent DSDT of my Motherboard.
I try to replace VBoxHFS.EFI and KP...need to change booting with USB.
Any idea? please!!
Thank so much