- Joined
- Nov 8, 2013
- Messages
- 89
- Motherboard
- Asus ProArt Z490 Creator-10G
- CPU
- i9-10850K
- Graphics
- RX 580
- Mobile Phone
Yes, thanks! I had found this page earlier, which is why I began looking into using OCAT to add the needed kext and .aml files, and edit config.plist. I supposed I could have used PepperTree, etc. (the "old" way) but OCAT looks like it's a much better tool. Hence the questions above (original post edited).Your I225V probably needs a fix
OC-Little-Translated/01_Adding_missing_Devices_and_enabling_Features/Intel_I225-V_Fix_(SSDT-I225V) at main · 5T33Z0/OC-Little-Translated
ACPI Hotpatches and Guides for the OpenCore Bootmanager. Enhance and fine-tune your system by adding devices and enabling additional features not covered in the OpenCore Install Guide. - 5T33Z0/OC-...github.com
The I-225V works fine on Monterey 12.6.6; it failed on upgrade to Ventura 13.4.
Also, these machines both triple-boot, so I'm hesitant to flash device firmware which might render the NIC useless in the other two OS.