- Joined
- Jun 5, 2015
- Messages
- 23
- Motherboard
- ASUS ROG Maximus VIII Hero Z170
- CPU
- i5-6600K
- Graphics
- GTX 970
Hello everyone,
This week I build my new desktop and planning on dualboot!
I need help for sure cause im not experienced and know ing that skylake is a bit harder
My specs are
Asus Maximus VIII Hero
i5-6600K
Gigabyte GTX 970 G1 Gaming
Ram:2x8gb(3000Mhtz,Ripjaws 4)
Samsung EVO 500GB
Coolermaster storm trooper
Coolermaster neptune 240m
I successful make my USB with UniBeast 6.1.1 with El Capitan 10.11.03, and I get to the Clover boot screen. But, I can't get to installation. I finally get black screen with a white circle and a line across!
By reading the Skylake starter guide, I copied the cofig plist from starter guide. My EFI partition of USB on kexts folder other ,10.11 and 10.10 the following
Thanks a lot, any advice is appreciated!!
View attachment verbose mode 1.pdf
This week I build my new desktop and planning on dualboot!
I need help for sure cause im not experienced and know ing that skylake is a bit harder
My specs are
Asus Maximus VIII Hero
i5-6600K
Gigabyte GTX 970 G1 Gaming
Ram:2x8gb(3000Mhtz,Ripjaws 4)
Samsung EVO 500GB
Coolermaster storm trooper
Coolermaster neptune 240m
I successful make my USB with UniBeast 6.1.1 with El Capitan 10.11.03, and I get to the Clover boot screen. But, I can't get to installation. I finally get black screen with a white circle and a line across!
By reading the Skylake starter guide, I copied the cofig plist from starter guide. My EFI partition of USB on kexts folder other ,10.11 and 10.10 the following
- USBInjectAll.kext
- IntelMausiEthernet.kext
- From the starter guide also i took this SSDT-USB-Maximus-VIII-Hero.aml (compiled SSDT) and copied to EFI/CLOVER/ACPI/patched
Thanks a lot, any advice is appreciated!!
View attachment verbose mode 1.pdf
Attachments
Last edited by a moderator: