- Joined
- Jan 27, 2014
- Messages
- 421
- Motherboard
- ASRock Z490 phantom gaming ITX/TB3
- CPU
- I9 10850k
- Graphics
- RX 5500 XT/UHD 630
- Mobile Phone
Hi,
I don't have a TB3 device to test yet but I would like to verify that I have set the onboard TB port correctly.
Here is what I did:
and listed on the USB tab
In IOREG
When I check the PCI section in system report, I don't see the TB port but I don't know if it only shows something when a device is plugged.
Note that I mapped my USB ports before looking at enabling TB; should I put back usbinjectall kext and do the mapping again or it's not needed? Shouldn't the port be seen by Hackintool with two personalities like USB3 with one for TB and one for USB-C?
Thanks a lot!
I don't have a TB3 device to test yet but I would like to verify that I have set the onboard TB port correctly.
Here is what I did:
- installed the SSDT for my motherboard from Hackindrom website checking that the proper port is used(RP21); it is
- Installed DTPG SSDT
- Enabled Thunderbolt in BIOS disabling security
and listed on the USB tab
In IOREG
When I check the PCI section in system report, I don't see the TB port but I don't know if it only shows something when a device is plugged.
Note that I mapped my USB ports before looking at enabling TB; should I put back usbinjectall kext and do the mapping again or it's not needed? Shouldn't the port be seen by Hackintool with two personalities like USB3 with one for TB and one for USB-C?
Thanks a lot!
Last edited: