Contribute
Register

ASRock Z490 Gaming Phantom ITX/TB3: Is onboard Thunderbolt port properly configured?

Status
Not open for further replies.
Joined
Jan 27, 2014
Messages
375
Motherboard
ASRock Z490 phantom gaming ITX/TB3
CPU
I9 10850k
Graphics
RX 5500 XT/UHD 630
Mobile Phone
  1. iOS
Hi,

I don't have a TB3 device to test yet but I would like to verify that I have set the onboard TB port correctly.
Here is what I did:
  • installed the SSDT for my motherboard from Hackindrom website checking that the proper port is used(RP21); it is
  • Installed DTPG SSDT
  • Enabled Thunderbolt in BIOS disabling security
In Hackintool TB is listed on the PCIe tab
Screenshot 2021-05-21 at 11.34.39.png


and listed on the USB tab
Screenshot 2021-05-21 at 11.35.36.png


In IOREG
Screenshot 2021-05-21 at 11.37.47.png


When I check the PCI section in system report, I don't see the TB port but I don't know if it only shows something when a device is plugged.

Note that I mapped my USB ports before looking at enabling TB; should I put back usbinjectall kext and do the mapping again or it's not needed? Shouldn't the port be seen by Hackintool with two personalities like USB3 with one for TB and one for USB-C?

Thanks a lot!
 
Last edited:
Status
Not open for further replies.
Top