AMD Radeon Performance Enhanced SSDT

[slim.jim]

I'm not sure whether Adobe Suite CC 2020 nowadays works with Metal libraries or they still rely upon Opengl ... it would be interesting - at least for me - to see if I can have a boost in performance with them, especially Photoshop, Lightroom and Premiere.

AS @slim.jim said, I can see only the GPU's memory and processor occupation, but not the energy. I'm using VirtualSMC and its sensors along with iStat. How can I measure the energy of the system? do I have to change kexts?

Photoshop (screenshot below) for example uses OpenGL/OpenCL. Premiere though, supports Metal and OpenCL.

 

[MasterHouse]

@mattystonnie

Could you please help me customise your RX 580 SSDT to fix my build?

The paths are: Display - PciRoot(0x0)/Pci(0x3,0x0)/Pci(0x0,0x0)
HDMI Audio - PciRoot(0x0)/Pci(0x3,0x0)/Pci(0x0,0x1)

Vendor: AMD (0x1002)
Device ID: 0x67df
Revision ID: 0x00ef

I use Clover in this build, in legacy mode. Currently I am injecting in Clover, otherwise I get black screen in HDMI or DVI. Unfortunately I do not have DP to test.

Thanks a lot for the fantastic work you are doing here.

All The best

 

[6rollo6]

Does this SSDT also work with RX570? @mattystonnie

 

[mattystonnie]

Does this SSDT also work with RX570? @mattystonnie

Yes, it should work.

 

[MasterHouse]

Following the instructions in the first post I only get black screen in both HDMI or DVI. The only way I can get video is by injecting in Clover using Orinoco as the Framebuffer. But the problem is that, by doing so, I have no hardware acceleration (as Videoproc tells me).

Attached is my actual EFI.

If anyone could help me in that regard, that would be awesome.

Thanks a lot

 

[Jasonhacks]

Following the instructions in the first post I only get black screen in both HDMI or DVI. The only way I can get video is by injecting in Clover using Orinoco as the Framebuffer. But the problem is that, by doing so, I have no hardware acceleration (as Videoproc tells me).

Attached is my actual EFI.

If anyone could help me in that regard, that would be awesome.

Thanks a lot

Try this EFI. Also try sleep/wake cycle for acceleration if dual monitor is connected. As for dgpu encode/decode use SMBIOS iMacPro 1,1

 

[yanisalbert]

Hi all,
I updated Clover to 5117, consumption was 95-100w and in Videoproc GPU N/A detected. I put back 5116, it' s ok .

 

[Jasonhacks]

Hi all,
I updated Clover to 5117, consumption was 95-100w and in Videoproc GPU N/A detected. I put back 5116, it' s ok .

Make sure Orinoco Framebuffer is injected. Check your ioreg

 

[yanisalbert]

Make sure Orinoco Framebuffer is injected. Check your ioreg
View attachment 469089

In Clover Configurator, it is ticked and in ioreg i've this

 

[Jasonhacks]

In Clover Configurator, it is ticked and in ioreg i've this

that for Clover 5117?