Ok well it appeared to be my monitor?
I unplugged it from my LG 4K and plugged the HDMI into my MSI 2K and it showed up on my 2K no issue.
Not sure what that means but i suppose i'm going to have to do more searching on that front.
Thank you again for all you do. How can i repay you for all...
CFG Lock Disabled in Boot (using F9j bios)
Serial Port Disabled
All other settings according to post #1
Initial Display Output IGFX
Internal Graphics Enabled
DVMT Pre-Allocated 64M
DVMT Total GFX Mem 256M
No joy :(
ahh ok i'm using the EFI you sent me a bit back which worked in the 8700k system with iGPU. I would assume the ig-platform-id is different for the 9900k?
Edit: attached zip of OC EFI from previous post :)
Here is the last readout i see before the screen goes black
Only other changes I made outside of the upgrade from the i7 8700k to the i9 9900k was that I installed a larger AiO cooler that is now using F_USB1 for what i can only assume is data and RGB. I just wanted to throw that in, in case...
So I replaced my 8700K with a 9900K and i can't seem to get this to work now :( do i need to edit anything in the last EFI you priovided me to make this boot? right now i'm just getting the NO symbol when booting.
@pastychef this seems to be a new thing considering I'm utilizing the CNVI on the motherboard. Would there be something that would have to be enabled to allow bluetooth to be seen?
I'm using your configuration with itlwm_v1.0.0_stable.kext, IntelBluetoothFirmware.kext, and...
I think that I'm not seeing success with this intel wireless and bluetooth kext (mostly because I'm not seeing them installed)
is there anything that would not have the CNVI enabled or something?
EDIT: Using HeliPort with the IntelWireless kext. It for sure works! Now to...
It worked! I need to do some post-installation and I'll let you know how it all went.
The only kext I'm adding to this is the newly stable Intel wireless kext (here https://github.com/OpenIntelWireless) as I have the CNFI card that is suggested for this board.
is there anything I need to change in the EFI to accommodate iGPU over dGPU in your zip files? I know at one point you linked an iGPU setup for Clover, but I've been setting up for using OC but not totally sure if there is anything else that needs addressing in the settings for iGPU +...
It's been a minute but I have an issue I'm trying to sort out. It may be basic but I also have a minor learning disability so here goes.
I'm going to use your OC0.6.0 zip though I have a few questions:
In my tower, I have a 2080 that I'll clearly not be using. Is there a setting or patch I...