Recent content by nonloc

Just an update. Did a little OCing on it by simply boosting the Turbo speed state to 4.5GHz, and it easily exceeded 20K on Geekbench: Single: 5364 Multi: 20750 Still runs cool and quiet, VCore remains close to baseline standard (went from 1.296V → 1.328V). There's probably a lot more...

Same here. Getting through the initial install is easy, and can be accomplished just like any other Hackintosh on previous chipsets once IOAPIC 24-119 is disabled in BIOS (or circumvented with the Pike patch).

Just ran it in 64-bit; haven't done any overclocking. Single: 5122 Multi: 19133 Integer 4910 21753 Floating Point 4868 22702 Memory 6057 6758

I have this board up and running fine with OS X 10.11.2 (via Clover UEFI v3330). Audio: Works using toleda's latest Skylake-compatible patches (ty toleda). A minor issue is that sound seems to shut off in OSX after ~10 seconds of inactivity, and upon reactivation the 1st initial bit of...

In FakeSMC.kext/Contents/Info.plist, remove REV, RVBF, RVUF from IOKitPersonalities→Configuration→Clover. End result should be like so: AFAIK, 2.15f7 is the latest SMC Version for iMac14,2.

Mine operates in silent mode and it's never seemed to have a problem. Though the connector for this fan is a 3-pin header, which might make a difference. http://www.fractal-design.com/home/product/case-fans/silent-series-r2-140mm

I use Clover UEFI with mine and it works swimmingly. Not much difference overall compared to Chameleon, other than that it shaves a few seconds off my boot time and can be set to load my XMP profiles so they're recognized at the OS level.

I explicitly wanted a case without an optical drive slot, and chose the Fractal Node 304 as it was one of the few without it. It's an excellent case—sturdy, quiet, cool, and aesthetically pleasing. Would def. recommend.

Interesting. My Z87E-ITX board says C2 in the BIOS, and I remember it having some shiny "NEW" sticker on the box back when I got it late October.

I'm experiencing the same problem.

Article: OS X 10.9.2 Update Same issue here. Only connecting it to DVI doesn't resolve the problem. I had run into this before when I first built my computer, and was able to resolve it by adding IntelAzulFB=10 to the Chamelon boot.plist settings. But that no longer works.

Article: OS X 10.9.2 Update Updated to 10.9.2. Monitor goes black after the Apple logo on bootup. Deleting 'IntelAzulFB=10' from org.chameleon.Boot.plist enabled me to use my system now, but the integrated graphics are no longer recognized and I'm getting bad screen flicker in Safari...

This might give you an idea:

Yeah, your speeds are good for 1866—see JEDEC standards here.

Confirming that here. I patched a v2.10G BIOS using the method you described—worked without a hitch. BTW for those looking to expedite bootdisk creation, Rufus is a good tool. With it you can create a bootable DOS USB in seconds w/o any additional downloads necessary. I think it's just a...