Contribute
Register

Recent content by kazuma

  1. kazuma

    Solving NVIDIA Driver Install & Loading Problems

    Hi! I wanted to know what the situation is with Pascal + G-Sync + Mac OS X. I had tried everything, but every time I started the disk with Windows 10, I had to unplug and connect the DisplayPort cable. Has there been any improvement on this situation? King Regards!
  2. kazuma

    NVIDIA 'Pascal' Graphics Drivers Released: Buyer's Guide Updated!

    Hello everyone. I tried installing Sierra and everything works perfectly. The only thing I noticed, however, is a problem with the G-SYNC. When I am on the MAC and restart my computer to enter Windows, the G-SYNC is not recognized. I must disconnect and connect the DP again. Does anyone know...
  3. kazuma

    G-sync no longer recognized after booting into OS X Yosemite

    Hi, some news about the problem? I too have this problem. Every time I enter Windows, I necessarily have to disconnect and reconnect the DisplayPort.
  4. kazuma

    NVIDIA Announces 'Pascal' Graphics Drivers Coming to MacOS

    Finally! :mrgreen::headbang::clap:
  5. kazuma

    [SOLVED] Nvidia GeForce GTX 1080/1070

    Really? So all Pascal will be supported, I do not think only the GTX 1080, right?
  6. kazuma

    UniBeast: Install OS X El Capitan on Any Supported Intel-based PC

    Thanks so much. In my BIOS I find no voice HPET 64 bits , but only HPET = Enable / Disable. I assume, by enabling it, is already 64-bit . Right?
  7. kazuma

    UniBeast: Install OS X El Capitan on Any Supported Intel-based PC

    I've a Question: I'm waiting for the release of new Web Nvidia drivers for my 1070 GTX. I remember HPET was essential to make the Mac. With Skylake still it needs to be enabled the HPET in the BIOS, or I can leave it disabled? Thanks so much!
  8. kazuma

    My New Build (Your own opinion !important)

    Greetings to all! I am building this new computer. I saw that the mother "Asus Maximus VIII Alpha Hero" card is in the list of compatible motherboards. I post my configuration: Motherboard: MB Intel 1151 ASUS Maximus VIII HeroAlph [90MB0P50-M0EAY0] CPU: CPU Intel Socket 1151 i7-6700k Ci7 Box...
  9. kazuma

    GA-Z77X-UD5H Rev 1.0 or 1.1?

    Thank you for your prompt reply! I use both Windows and Mac OS X. I would not change every time the door to restart the computer. I wanted to know if there was someone with the Rev 1.0 and if with the last bios, had solved the problem. Thanks so much! Best regards!
  10. kazuma

    GA-Z77X-UD5H Rev 1.0 or 1.1?

    Greetings to the whole community! I probably found the GA-Z77X-UD5H at a good price. But it is REV 1.0. I read that it is suffering from a bug audio (If you install an operating system other than Windows, inserting the jack in the green door, there is no sound!). Someone please tell me...
  11. kazuma

    Unibeast 6.1 doesn't boot clover, 6.01 yes

    I wanted to create a separate thread, but, apparently, my hunch was right: UniBeast 6.1, at least for me, that I installed with Legacy Support, is not working.If it imposed as a key to boot from the UEFI bootloader part, but leaves an error while reading the USB key for installation.
  12. kazuma

    Post OS X Cinebench CPU and Graphics Benchmarks

    » OS X El Capitan 10.11.1 » Asus Maximus IV Extreme-Z » i7-2600K » AMD Radeon HD 7970 Tahiti XT
  13. kazuma

    Geekbench 3 Test Result ,normal ?

    Hi Mta! Sorry for late response. Probably we should act step by step: 1) Create a DSDT valid for your Motherboard (I say this, because I see the orange icon on your hard drive and, therefore, see your hard drive as external) 2) Skip the table of DSDT Do you know how to use MaciASL...
  14. kazuma

    Geekbench 3 Test Result ,normal ?

    Hi, Mta. Look ... For me, no. I think there is a problem with C-States and the P-States. Try to disable them by config.plist of clover. DropOEM and uncheck Generate PStates and GenerateCStates.
  15. kazuma

    Asus Maximus IV Extreme-Z

    Anyone? :(
Top