Booting up now, fingers crossed...
Selected boot macOS from SSD...
Apple shows, progress bar...
gets about 3/4 goes back to clover boot,
2nd time, log in...
password and BINGO!!!! IT WORKS!!!!
About this mac says, Radeon RX 570 4096 MB!!!
Anything Else?
This is fantastic!!! Thank you Gigamaxx!!!
Picked up a XFX RX 570 4gb at Best Buy today. It was on clearance for $189, so I grabbed it. Do I just pop it in and turn off internal graphics or is there a big install process?
Thanks, Which one for OOB?
The XFX RX 570 is available for in store pickup.
Best Buy: XFX - AMD Radeon RX 570 4GB GDDR5 PCI Express 3.0 Graphics Card for $199
or
Amazon: Gigabyte AORUS Radeon RX 580 8GB Graphic Cards GV-RX580AORUS-8GD for $229...
Guys, I got so sick of the Nvidia issue I went to Best Buy today and bought a:
XFX - AMD Radeon RX 560 4GB GDDR5 PCI Express 3.0 Graphics Card
Any tips on how to make this work? Or should I start another thread?
Hi,
I'm stuck. After years of running pain free Yosemite I upgraded to High Sierra. Had to remove the Evga Gt-740 SC 2GB video card and run internal graphics to get up and running.
Now what? How do I get the video card working? I have read so much and honestly I am confused because there are so...
It did not show in disk utility. I have CC. Thinking it may be time to start over as the Clover config is not working in current build. Any pointers on starting over with new config with the aim of getting the GT-740 to work?
OK, SOMEHOW I GOT IT TO BOOT AN OLD YOSEMITE EXTERNAL DRIVE USING GT-740!!! So I'm not in HS, but the HS startup SSD is not showing up in finder.
Now what?
Should I do a fresh install? If so what settings to get the GT – 740 working?
Totally wrecked my day. Got no work done as this is my main computer. Put the GT-740 back in because the onboard graphics wouldn't work. Did everything you suggested in 1st post, verbose mode says this:
ERROR!!! Load prelinked kernel with status 0x800000000000000e
Error loading kernel cache (0xe)
This is what trashed my hack, before this is booted fine with Intel on board graphics. Something is these instructions is causing the startup problems. My main mission now is to undo this but all I can get to is the Clover boot screen. What can I do to get back to where I was?
Open Config.Plist...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.