Recent content by alibotan

very nice :) well done, boy :lol:

I have not found big difference. The Settings is same. It boots a little faster. But not so noticeable. Everything runs smoothly. :thumbup:

:lol:Yes, that would be nice. I have already installed. :headbang:

Bios Version 1402 is out :thumbup:

i used Unibeast. And i always had these inputs "fixes" and other inputs in my usb config.plist but i don't know why.

Hi Stork, My system boot very slow. From the clover boatloader it takes about 45 seconds. And in my config.plist there is more inputs than yours. For example <key>Fixes</key> and i use a 250 GB samsung eve 850 only for Hackintosh. i add my config.plist on attachments. Thanks in advance :thumbup:

in boot menu select Options and write in Boot Args: dart=0 kext-dev-mode=1 rootless=0 nv_disable=1 -v then boot it.

:thumbup: Thanks

Do u use a USB 2.0 or 3.0 ?

in Bios --> IOAPIC 24-119 --> disable if don't work then create ur USB with IOAPIC fix http://www.tonymacx86.com/el-capitan-desktop-guides/179221-skylake-starter-guide.html

Dude thanks for Info :D

I have it installed ready. Everything is as Stork Guide. I will write here only extras. I installed it so; For my system, I should make, namely First i created USB with IOAPIC fix and booted with dart=0 kext-dev-mode=1 rootless=0 nv_disable=1 After installation; MultibBeast>> :ch...

I again installed it but the result was same. I can only boot from the usb when I create the USB with IOAPIC Fix (Skylake Starter Guide). After installation I have selected in the Multi Beast Quick Start > UEFI Boot Mode :ch: Drivers > Audio > Realtek ALC1150 :ch: (Optional) Drivers > Disk...

MacPro3,1 and other same like ur Guide. I create again my usb with unibeast. I hope this time will be all ok :D

I finally installed the system. When I install USBInjectAll.kext(USBInjectAll_2015_1230) then shuts down the system directly, and will not boot it.