- Joined
- Sep 21, 2010
- Messages
- 13,413
- Motherboard
- HP 17" 17-by3053cl
- CPU
- i5-1035G1
- Graphics
- Intel UHD Graphics, 1920x1080
- Mac
- Classic Mac
- Mobile Phone
Try using another USB port. I use the one of the two under the Ethernet port on the Back Panel.So I was able to fix the USB being recognized. I still had the scheme as MBR instead of GUID Partition (silly me); however, I am now getting an end randomseed error “++++++++++++++++++” when trying to install using a Unibeast install drive. I’ve tried adding the SSDT and Kexts from the original post in my EFI folder on my drive. (Not sure if that was the best move). Are there any other required kexts or boot args I should use while installing on this board? Right now I have the Unibeast defaults (dart=0 Nv_disable=1) and have added -x -v.
Disclaimer: It has been a while since I have really worked on an install, like 2011. I have started looking at OpenCore as suggested in the original post, but dont have another personal computer at this time to experiment fully. Was hoping to maybe get this started with Clover then make a switch in bootloader later.