- Joined
- Dec 7, 2017
- Messages
- 37
- Motherboard
- ASUS ROG Strix HERO II Laptop
- CPU
- i7-8750H/HM370
- Graphics
- UHD 630+RTX 2060
- Mobile Phone
Hi!
I finally managed to get the installer to go past the initial stages and as long as I use my USB drive, I can successfully boot into Mojave. However, I am having a few issues with my installation.
-Clover says the installation was successful on my SSD, but I cannot see my SSD in BIOS, so I have to use my USB drive to boot into Clover, and then into Mojave.
-Trackpad does not work. VoodooPS2Controller makes the laptop restart itself when I try to boot into Mojave, and VoodooI2C simply does nothing.
-USB drives are not recognized by the laptop. However, the USB ports work fine as I am able to sync an iPhone and plug in a mouse just fine. I have USBInjectAll.kext installed.
I will attach the EFI folder that is on my USB drive that I use to boot. I am using the config.plist for UHD 630.
I believe all I need to do is get Clover working on my SSD, get USB drives to work properly, use the config/EFI that I have on the USB drive. From there, I can sort out things like audio and my trackpad.
As a side-note for the USB issue, USB drives will not show up in terminal with diskutil list or in Disk Utility on my laptop.
I finally managed to get the installer to go past the initial stages and as long as I use my USB drive, I can successfully boot into Mojave. However, I am having a few issues with my installation.
-Clover says the installation was successful on my SSD, but I cannot see my SSD in BIOS, so I have to use my USB drive to boot into Clover, and then into Mojave.
-Trackpad does not work. VoodooPS2Controller makes the laptop restart itself when I try to boot into Mojave, and VoodooI2C simply does nothing.
-USB drives are not recognized by the laptop. However, the USB ports work fine as I am able to sync an iPhone and plug in a mouse just fine. I have USBInjectAll.kext installed.
I will attach the EFI folder that is on my USB drive that I use to boot. I am using the config.plist for UHD 630.
I believe all I need to do is get Clover working on my SSD, get USB drives to work properly, use the config/EFI that I have on the USB drive. From there, I can sort out things like audio and my trackpad.
As a side-note for the USB issue, USB drives will not show up in terminal with diskutil list or in Disk Utility on my laptop.