- Joined
- May 7, 2019
- Messages
- 9
- Motherboard
- Asus Rampage III Formula (X58)
- CPU
- Xeon X5690
- Graphics
- AMD R9 Fury X
I am confused/stuck/Need help...
I formatted the disk properly, I installed Mojave. I rebooted into the USB/Clover and now looking at the 2 drives to select. HFC and External. If I click HFC, nothing happens. External will take me back to Clover again? How do I get into Multibeast so I can finish the installation and make my disk bootable?
I used Legacy mode because my mobo doesn't have a EUFI (Asus Rampage III Formula)
I followed all the recommended bios settings. I disabled VT-d, do I need to disable Intel virtualization as well?
I see it says to disable USB3 with Award Bios, mine is not award, so I left it enabled.
What do I do now?
The instructions do not show how to get into MultiBeast.
It says:
P.S.
I rebooted into the USB and it installed more, but now I am in Closer and have still no idea what to do.
I see:
External: Boot macOS Install from Install macOS Mojave
APFS: Boot FileVault Prebooter from Preboot
APFS: Boot macOS Install Prebooter from Preboot
APFS: Boot macOS from OSX Mojave
Recovery: Boot Recovery from Recovery
Which one do I choose? Don't want to screw anything up at this point.
Thanks
I formatted the disk properly, I installed Mojave. I rebooted into the USB/Clover and now looking at the 2 drives to select. HFC and External. If I click HFC, nothing happens. External will take me back to Clover again? How do I get into Multibeast so I can finish the installation and make my disk bootable?
I used Legacy mode because my mobo doesn't have a EUFI (Asus Rampage III Formula)
I followed all the recommended bios settings. I disabled VT-d, do I need to disable Intel virtualization as well?
I see it says to disable USB3 with Award Bios, mine is not award, so I left it enabled.
What do I do now?
The instructions do not show how to get into MultiBeast.
It says:
- Press the hotkey to choose boot device (F12 for Gigabyte motherboards, F8 for ASUS motherboards, F11 for ASrock motherboards)
- Choose USB
- At the Boot Screen, choose your new Mojave installation. (Is this the Mojave on the USB or Hard drive?) It doesn't boot yet.)
- Complete macOS setup
- Open and run MultiBeast
P.S.
I rebooted into the USB and it installed more, but now I am in Closer and have still no idea what to do.
I see:
External: Boot macOS Install from Install macOS Mojave
APFS: Boot FileVault Prebooter from Preboot
APFS: Boot macOS Install Prebooter from Preboot
APFS: Boot macOS from OSX Mojave
Recovery: Boot Recovery from Recovery
Which one do I choose? Don't want to screw anything up at this point.
Thanks