Contribute
Register

macOS Native CPU/IGPU Power Management

but AppleIntelInfo.kext doesn't list them (they were run at the same time)
IPG ran a lot longer than AppleIntelInfo.kext
Run AppleIntelInfo.kext for ten minutes, reply with new output
 
Hello, I've been trying to get power management working for a couple of days but without success.

When I remove NullCpuPowerManagament I am able to boot successfully for a short period of time (less than a minute) after which the system freezes for a few seconds and then reboots. AICPUPM is patched in config.plist/KernelAndKextPatches.

I would really appreciate some help
 
removing AICPUPM.kext fixed it, thanks
Bad idea, the request described Clover config settings as noted:
AICPUPM is patched in config.plist/KernelAndKextPatches.
Without the kext, no native CPU PM possible
Restore the kext
Note: this thread does not apply to your system, see Post #1/Supported CPU/IGPU/1. Ivy Bridge ...
 
Hi.
I have a Dell 3542 laptop with : i3-4005u 1.7ghz , Intel HD 4400 , 8GB ram.

I'm on Mojave 10.14 and i would like you to ckeck if my power management (cpu+gpu) is working at it should.

I'm more concerned about gpu frequency , it. stays at minimum 200 even when i'm playing mkv video (see photo) , when in windows 10 at the same video gpu does all the job. Same minimum 200 when converting video with videoproc (even thought videoproc shows h264acceleration).

Thank you in advance.
 

Attachments

  • AppleIntelInfo.txt
    11.4 KB · Views: 95
  • BootLog.txt
    25.4 KB · Views: 133
  • Clover.zip
    33.3 KB · Views: 96
  • config.plist
    8.4 KB · Views: 209
  • Intel Power Gadget.png
    Intel Power Gadget.png
    839.6 KB · Views: 125
  • MacBook Air.ioreg
    3.7 MB · Views: 112
Not sure if I'm right in that thread.
My CPU is using the different speeds f.e. it goes down and up depends on the load. Thats fine.
But when the PC is going to sleep I have several issues (graphic card, USB devices) - So could someone advice me how to deactivate the sleep mode?
 
my CPU broadwell i3 5010u, but when i made following rehabman, IoReg not show x86platformplugin, but i check appleinfo.kext it have Cpu Pstates and igpu, testing with intel power gadget, CPU run in range 1.0~2.1 Freq.
How to do native cpu or is it native power management?
Thanks
 
Back
Top