USB accessories disabled error

[Aaron234581]

What do I do?

 

[VioletDragon]

What do I do?

Well. Instead of using EHCI Controllers id personally set XHCI to Enabled in the BIOS.

 

[Aaron234581]

I could almost swear it is, but I'll double check. If it's not anything I need to change in config before I turn it on?

 

[VioletDragon]

I could almost swear it is, but I'll double check. If it's not anything I need to change in config before I turn it on?

If XHCI was set to Enabled and not Auto or Smart Auto then EHC1, EHC2 will not show in ioreg.

 

[Aaron234581]

If XHCI was set to Enabled and not Auto or Smart Auto then EHC1, EHC2 will not show in ioreg.

It was 'XHCI Handoff' I knew was on. 'XHCI Mode' was on Smart Auto. Changed it to Enabled and here's the ioreg after the reboot. Still having issues.

 

[VioletDragon]

It was 'XHCI Handoff' I knew was on. 'XHCI Mode' was on Smart Auto. Changed it to Enabled and here's the ioreg after the reboot. Still having issues.

Ioreg looks better. XHCI Handoff needs to be enabled. You need to remove Ports that are not used. Your going way over the 15 Port Restrictor. Take a look at [Guide] 10.11+ USB changes and solutions | tonymacx86.com

 

[Aaron234581]

I looked over that, and most of it makes no sense to me. I deciphered what I could and I got a bigger problem now.

Near the bottom are "Specific Recommendations", I tried the FakePCIID.kext one, with FakePCIID_XHCIMux.kext. Immediately after installing them with Kext Wizard as suggested I lost all USB. Reboot didn't help. I have USB until the Apple logo comes up. I can't even get into OSX using the Unibeast USB. I'm in Safe Mode, but still no USB.

I'm doing this from another computer now.

How can I get in there to remove those kexts if I don't have USB?

 

[vulgo]

How can I get in there to remove those kexts if I don't have USB?

Maybe you can enable SIP and boot without caches.

 

[Aaron234581]

Maybe you can enable SIP and boot without caches.

And how would I go about that? I'm assuming it's a boot flag in Clover, just not sure what.

 

[vulgo]

And how would I go about that? I'm assuming it's a boot flag in Clover, just not sure what.

Hit 'o' at boot menu for clover options. CSR Active Config to 0x0 -> check unsigned kexts. Unless you installed FakeSMC to your EFI folder, you probably need to boot with that Unibeast USB you mentioned.