UniBeast: Install macOS Sierra on Any Supported Intel-based PC

[kwes]

What drivers do you install if u using just the onboard graphics cards

 

[Feartech]

What drivers do you install if u using just the onboard graphics cards

you need to fill out your hardware profile as per rules, then others maybe able to help you

 

[Zivota]

My post moved to Sierra on Dell XPS m1730...I don't have PC that is reason why I didn't fill hardware profile I have only this laptop...my apologize for administrators cause i replied in wrong thread.. I can't even make bootable USB. I downloaded Sierra with my friend's MacBook Air (early 2010) but UniBesst says that installation isn't complete. I deleted all downloaded all again and same happened.

 

[kblab]

I followed this procedure step by step and everything is working fine except the audio ,I checked the system and found no sound output devices detected. Anyone could help me!
I have a Gigabytes Z170x ud3 motherboard with audio chipset ALC1150.

 

[Feartech]

I followed this procedure step by step and everything is working fine except the audio ,I checked the system and found no sound output devices detected. Anyone could help me!
I have a Gigabytes Z170x ud3 motherboard with audio chipset ALC1150.

https://www.tonymacx86.com/threads/audio-realtek-alc-applehda-guide.143757/

 

[kblab]

https://www.tonymacx86.com/threads/audio-realtek-alc-applehda-guide.143757/

Thanks a lot, need to study first.

 

[Feartech]

Thanks a lot, need to study first.

it would be good if you updated your hardware profile as per rules

 

[fgxr8]

guys followed all the steps

but getting this error once installer is couple of minutes in.

 

[GigaDon]

On his Mac, log into your account. If it gives you the already installed message, it should give you the option to download it again. If not, click Option-Purchaces to see if it's in the Purchases list. You can redownload Sierra anytime. But, be sure to use your MAS account, not his. If you don't have an account, make one.

Thanks Stork, Your solution worked perfectly for me. New challenge though!At the last screen of the UniBeast setup, I'm getting another error, "There was an error creating your UniBeast drive: Couldn't enable ownership".

Please HELP!!!

 

[Stork]

Thanks Stork, Your solution worked perfectly for me. New challenge though!At the last screen of the UniBeast setup, I'm getting another error, "There was an error creating your UniBeast drive: Couldn't enable ownership".

Please HELP!!!

See the following:
https://www.tonymacx86.com/threads/unibeast-7-troubleshooting-notes.203153/

If the above thread does not offer up a solution, see
https://www.tonymacx86.com/threads/unibeast-failure-reporting.85364/
and open a thread in the UniBeast forum section.