Multibeast 8.0 "Configuration file corrupted"

[proximo]

I just finished upgrading to El Capitan, the easiest, least eventful, hack upgrade in the last several years. Well done, guys.

Unfortunately, I've run into a problem with reloading a saved Multibeast configuration. Every time I try it, the load fails with the message: "Configuration file corrupted. Not able to load it." My configuration and the error message are attached.

 

[sporkman]

FWIW, I see the same thing here. MB 8.0.1(1).

I saw it a few times with an older version of a config file from MB 7.x and figured it was my error in trying to load an older config, but I just saw it today when trying to load a saved config I had just created in MB 8.0.1 (1).

 

[pisomojado]

I just migrated to Clover, jumping from Mavericks to El Capitan. Got the same error. The weird thing is, I saved a new config file, and it says that's corrupted too. Tried multiple times. Also, no audio after sleep (ssdd).

 

[BarryS]

I just migrated to Clover, jumping from Mavericks to El Capitan. Got the same error. The weird thing is, I saved a new config file, and it says that's corrupted too.

I'm experiencing the same behavior. I jumped from Chimera+Yosemite to Clover+El Capitan. Multibeast 8 would not load my old config file, saying it was corrupted. So, I just created a new one. However, when I try to load the new config file (created in Multibeast 8), it also says the config file is corrupted.

 

[Uhlhorn]

I have the same problem with version 9.1.0 (1) of MultiBeast. I save the settings and try to open it again and MultiBeast says it is corrupt.

 

[ssuede]

Multibeast 10.1.1 also reports "Configuration file corrupted" and only partially loads settings from the file.

 

[bentfrog]

Same issue..version 10.2.0 . Any solutions ?
Thanks