RehabMan
Moderator
- Joined
- May 2, 2012
- Messages
- 181,016
- Motherboard
- Intel DH67BL
- CPU
- i7-2600K
- Graphics
- HD 3000
- Mac
- Mobile Phone
AGPM isn't going to work without ACPI_SMC_PlatformPlugin.kext
Noticed that too in the ioreg...
AGPM isn't going to work without ACPI_SMC_PlatformPlugin.kext
The guide I used to install the whole system said that I had to remove IOPlatformPluginFamily.kext. I installed it again, from installer stick. If I'm not mistaken ACPI_SMC_PlatformPlugin.kext is inside that kext. But my AGPM.kext says no.
Should I use "Mac-F22589C8" or "MacBookPro6,1"?
Should I use "Vendor10deDevice0a6c"(id of my GPU) or "GFX0" because I changed it so in DSDT.
Could you make installable kext with right values, please?
I made an IOReg, could you check if IOPlatformPluginFamily.kext and ACPI_SMC_PlatformPlugin.kext are loaded properly?
After fresh install, it loaded. BUT HWmonitor says that my frequency is 405 MHz, don't matter which g-state I am. Console log is switching, but my frequency isn't. Which one is right? Is it switching or not?
it is switching between G-States
Sorry I attached the file because I couldn't get it into this post