WIP Mac Pro 3.1 Mod, low budget and stock look

[Laverda]

Great build. Did you finish making the front panel and the rear I/O 3d printed frame?

Kind regards,
Laverda.

 

[Natnatfr]

Thanks !

As mentioned on your topic, I didn't finish are the front and rear I/O yet.
I made some drawings, printed but it wasn't at scale about 1/2 mm. I printed again with modifications, the front is still not adjusted like it should, and I didn't tried the rear yet (by laziness).
It's no big deal to me as I'm not using lot of USB ports, and when I do I have some on my desk.

 

[marinogutierrez]

No need, you just plug the power+ and led+ to your mobo, the the ground (middle) to power- on your mobo
For the led I first plugged it on the Led+ of my mobo but it was then always on even when the system wasn't on so I plugged it on the HDD-LED+ and now it turns on when the system turns on

I would NEVER figure this out !!! I was pulling my hair for a week now... THANKS !!