Unibeast USB boot causes CMOS error

[JeffRH]

Everytime I boot from the Unibeast ML USB, I appear to get a CMOS checksum error and defaults are loaded, causing my drive controllers to go back to IDE. Is there any solution to modify the Unibeast ML USB to remedy this problem?

 

[Nunkle]

I too am having this problem, also using an X58 chipset, I hear that it is due to the appleRTC.kext file in some way

 

[JeffRH]

I was able to install ML with the Unibeast USB, but I can't get it to boot from the disk. It boots fine from the USB. I'd be fine with that if it didn't cause a CMOS error everytime and reset all my CMOS settings back to default everytime!