- Joined
- Apr 30, 2018
- Messages
- 2
- Motherboard
- Gigabyte Z370 Ultra Gaming
- CPU
- Intel Core i5 7600k
- Graphics
- GTX 970
Hi,
I'm trying to make it through the installation process, and I've run into an issue I can't seem to solve.
At first it would just get stuck on the Apple logo. I turned on ACPI patching>DSDT fix mask>Fix Headers and verbose mode so I can monitor what's going on. That got me to the High Sierra setup page. However, my HDD wasn't showing up. I then tried the close/reopen Disk Utility trick - to no avail. I tried finding the disk through Terminal and it didn't show up there, either.
After reading up a bit, I added some patches as instructed by a previous post from someone (see attached config.plist file). That didn't fix it either.
Then I changed the SATA config in BIOS to AHCI. Now when I boot up it goes through part of the sequence, then restarts and I'm back in Clover. See video.
I'm trying to make it through the installation process, and I've run into an issue I can't seem to solve.
At first it would just get stuck on the Apple logo. I turned on ACPI patching>DSDT fix mask>Fix Headers and verbose mode so I can monitor what's going on. That got me to the High Sierra setup page. However, my HDD wasn't showing up. I then tried the close/reopen Disk Utility trick - to no avail. I tried finding the disk through Terminal and it didn't show up there, either.
After reading up a bit, I added some patches as instructed by a previous post from someone (see attached config.plist file). That didn't fix it either.
Then I changed the SATA config in BIOS to AHCI. Now when I boot up it goes through part of the sequence, then restarts and I'm back in Clover. See video.
Last edited by a moderator:
