(SOLVED) VIA VT2021 | Clover and El Capitan issue

[Suloo]

Hey,

what do i have to do to get my onboard sound working. I only see the Realtec guides but what about this via codec?

I'm new to clover and formely got it working with Multibeast by using a VoodooHDA. How can this be achieved with the VIA codec?

The device is seen in the system specs but not available in the preferences.



I do have sound, since i got an external firewire card but in case that one breaks it would be nice to have the onboard sound working as well.

thx

 

[jvdp1234]

Hi SUloo,

check here:
http://www.insanelymac.com/forum/topic/306562-applehda-for-el-capitan-discussion/page-13

you can find mirone's github repo here: https://github.com/Mirone/AppleHDA_10.11/tree/master/Desktop's

and the hda layout enabler here:
https://github.com/Mirone/HDAEnablers

perhaps this will help you.

 

[Suloo]

cool thx, will try and report back!

 

[SparkleHoof]

cool thx, will try and report back!

Did you get your VT2021 working? I'm in the same position - did a clean install with El Cap, and any AppleHDA patches I've found on the forums have only enabled my HDMI audi (comes out my monitor's built-in speakers) and not the back I/O

 

[Suloo]

no, couldn't get it to work sadly.
Now it tried with multibeast, but that is also only activating HDMI outs, but no analog or igital inputs. :/

 

[petonz]

This Method Work for me.

1.Use clover configurator. Goto Device Tab and Make Audio layout ID 9



2.Put AppleHDA.kext (Attached) on Desktop Run kextbeast Install to System/Library/Extension
3.Reboot. Then Got Your Sound Working
Tested on El Capitan 10.11.6
MOBO GA H77M-D3H
Audio Codec Via VT2021

 

[Suloo]

nice thx!

this works for me as well :