[Solved] New build, boot extreme slow

[RumpelHumpel]

Problem solved:


-disablegfxfirmware



Hi,

I built a new PC with following components:
- Asus ROG Strix z370-i
- Intel I7 8700
- Crucial 2x 8 GB
- Samsung EVO 960 NVME 256 Gb
- MSI GTX 1080

I used this guide to install
https://www.tonymacx86.com/threads/...ierra-on-any-supported-intel-based-pc.235474/

The installation went well without any problems.
I am using HFS+J as filesystem. Before that I used APFS.
Both the same problem.

Everything seems working so far.
But the boot time takes about 3 - 5 minutes.
Does anyone see the mistake in my configuration?

Thanks in advanced!

Regards
Lars

 

[P1LGRIM]

See Clover Wiki - Debug.

 

[RumpelHumpel]

Well do you mean that I had acitvated the debug for ACPI/DSDT or should I activate debug for troubleshooting?
Well attached the log file.

But I didn't activated debug, so it was there direct after the installation.

And I deactivated debug completely and it didn't solve the problem.
Still slow.

Progress bar is fast until 50% and then it's extremely slow.

I do not see anything in the debug log...

 

[RumpelHumpel]

Ok I got it...

Pasted from another thread my answer:


I activated the verbose mode (that I didn't come to this idea before ...) and I saw:
Begin Gfx firmware load process

.
.
Hash data from me never returned , status = 1, doing retry #1
and now it counts high

So -disablegfxfirmware did the trick.