[Solved] High sierra cant load after installation

[Gigamaxx]

It shouldn’t be, if you have a real Mac and a USB to Sata adapter you could install on the external drive and then add clover. Just make sure to select install disk during process.

 

[pravbk100]

It shouldn’t be, if you have a real Mac and a USB to Sata adapter you could install on the external drive and then add clover. Just make sure to select install disk during process.

I don't have real Mac right now, but I can get help from friends. Will check tomorrow. As always, thank you gigamaxx, for helping from those old "rx480" sierra enable days till now.

 

[Gigamaxx]

I don't have real Mac right now, but I can get help from friends. Will check tomorrow. As always, thank you gigamaxx, for helping from those old "rx480" sierra enable days till now.

You may try cpuid fake ID 0x0106E0 it seems to break through the kernel panic for me during updates on my pentium setup.

 

[pravbk100]

Lilu.kext, WhateverGreen.kext and FakeSMC.kext are all old and should be updated.
Boot with -liluoff and update them.

This worked out. I was neglecting this aspect as I didn't have lilu kext but again taking a look into verbose log and disabled it, now it's working.
Now the problem is not getting dp audio. Any solutions for that.

 

[P1LGRIM]

Now the problem is not getting dp audio. Any solutions for that.

For assistance with Audio you should post in the Audio forum.
Read the 'sticky' guides first and be sure to comply with the Problem Reporting instructions or you will not get any help.