[Solved] can't make my system boot

[BenCharbo]

Hello, i've tried many times but i can't fix it even after reading lot of things in this forum.

I have installed 10.13.2 via unibeast 8.1.0 and eveything is ok.

When i run multibeast (10.2.0) UEFI Boot mode and install it my system reboot again and again

I tried Clover UEFI Boot Mode v2.4K r4428 and it's the same problem.

I don't know the method to undo changes so i have to reinstall it from the usb stick, can someone help me to find another method ?

my config is Z370 HD3 P, i7 8700, 16Go ram, 250Go 840 evo SSD and intel UHD


thanks

 

[ashman70]

It's unclear from your post what exactly is going on after you run mutlibeast. Have you searched the forums using your motherboard model to find other threads/posts from people who have used your board model to build systems successfully? Have you made sure your BIOS settings are correct? There are so many variables that can result in problems and issues.

 

[BenCharbo]

i have solved my problem, starting over from here

https://www.tonymacx86.com/threads/...3p-uhd-graphics-630-macos-high-sierra.239402/

I don't know what I did bad I suppose it was a BIOS problem