Shutdown while Mac OS is installing on the SSD

[Invincibile]

Hi guys,
Yesterday i’ve built my first hackintosh, it is similar to Custom Budget ATX of the Installation Guide (H370 HD3, i3 8100, GTX 1050).
When I’ve tried to turn on it, video doesn’t work but after some times I’ve changed the USB port where I had connect Keyboard and mouse and it works.
Then I’ve set the BIOS with options of the installation guide of Mojave and then I boot the USB but I had problems with 3.0 and 2.0 ports, usb boot only with 3.1 port.
Then I was blocked at the language selection screen and keyboard and mouse didn’t work in any port but I’ve added USBInjectAll.kext and I’ve resolve it.
Now I have a new problem, when I try to boot Install Mac OS from my SSD, my hackintosh arrive at the installation of Mojave on the SSD screen and the bar goes for 30 seconds and then the system restart.
In my uploaded photos there is what happens with lines of verbose mode.. someone can help me please?

 

[lovemacloveyou]

I have the same problem to you, have you solved that?

 

[Invincibile]

Hi, I don’t know what were the problem, but with the bootflag -disablegfxformware and an appropriate fake ID and layout ID for the graphic card, after some attempts it works.
Anyway I advice you high sierra instead mojave because mojave is too less mature.

 

[lovemacloveyou]

According to the official tutorial, you can install 10.13 successfully？ What does the BIOS need to set?

 

[lovemacloveyou]

Thx for your apply, can I use the 10.13.6 dmg and unibeast 8.3.2 to make usb bootloader to install it?

 

[Dulricht]

Hi guys,
Yesterday i’ve built my first hackintosh, it is similar to Custom Budget ATX of the Installation Guide (H370 HD3, i3 8100, GTX 1050).
When I’ve tried to turn on it, video doesn’t work but after some times I’ve changed the USB port where I had connect Keyboard and mouse and it works.
Then I’ve set the BIOS with options of the installation guide of Mojave and then I boot the USB but I had problems with 3.0 and 2.0 ports, usb boot only with 3.1 port.
Then I was blocked at the language selection screen and keyboard and mouse didn’t work in any port but I’ve added USBInjectAll.kext and I’ve resolve it.

1. Can't you just take out the GTX1050, enable internal graphic, do the install and put it back after OSX is installed ? This is what I did for 10.14
2. I often have problems with USB3.0/2.0, they always work if put in before booting, sometimes they don't work if put after boot, I use USBINjectAll.kext all updated, but its not very stable for my setup. Keyboard on mouse work always for me.

If GTX1050 is not supported by default, why would you make your installation harder when putting kexts in the install ? load them after the installation is successful. Think of it as a real Mac User buys an eGPU, he already has installed OSX, then he install drivers for GTX1050 and it starts being recognized.
Radeon RX580 is another story it works out of the box on High Sierra+, Mojave included.