RTC: Only single RAM bank (128

[bgalakazam]

Fresh install, followed guide for BIOS settings. Gets stuck here.

Gigabyte X79-UP4
Xeon 1612v2
XFX RX 560
4x 8GB RAM

Ideas?

 

[P1LGRIM]

Ideas?

Boot in verbose mode and post a picture of the screen when it stops.

zip your /EFI folder and attach it.

 

[bgalakazam]

The installer got a little further after 5 tries. Looks like cpu power related? All my cpu options are auto in bios (with disabled vtd). Will upload efi in a few.

Nothing on the USB in the backed up EFI folder.

 

[cmn699]

The installer got a little further after 5 tries. Looks like cpu power related? All my cpu options are auto in bios (with disabled vtd). Will upload efi in a few.

View attachment 400408

Nothing on the USB in the backed up EFI folder.

• Since macOSM Mojave USB Installer Boot problems may be related to the authenticity of the (1)InstallMojave File , (2)the EFI_CLOVER FileTree , (3)the BIOS Options chosen for the boot for proper diagnosis and finding clues to the best troubleshoot step when boot failure occurs, you have to share the information about these 3 important components to get informed help.

• If you have downloaded the InstallMacOSMojave from App Store and it has the full file size ( if possible Sha1 checksum tested) and used a Terminal command or UniBeast method to copy the file on a Disk Utility Erased 16GB Flash Disk, it is good enough to be a genuine macOSMojave Disk.

• If you have installed Clover EFI on the MojaveInstaller Disk using Unibeast or Manually with your own input as prompted and then verified the auto mounted EFI _CLOVER File Structure's critical folders like drivers64, drivers64UEFI, kexts/Other , and config.plist SECTIONS to make sure that they all will help to make use of the Motherboard , CPU and add -on cards for a successful boot in Verbose Mode and Target Hard disk installation, usually there would be no booting problem

• Since CLOVER depends on a properly chosen BIOS options , this critical steps should not be cursory but a thoughtful and deliberate choice.
  • Add your current Motherboard+CPU+Graphics Specifications from the body of your post on #1 to the Build Signature for easy access from all your posts.
• Your macOSMojave USB Installer's EFI Partition is hidden and that is why you are unable to get CLOVER to attach to your post as a zipped file.
• Follow the bulleted steps from this post #4 and you will be able to find and upload CLOVER.
• You may also post your BIOS screen shots as JPG/PNG (not BMP) to the Forum if you follow the steps you can find here: #33