[RESOLVED] Update from HS to Mojave Gone Bad - Boot Disk Not Showing in Clover

[Feartech]

I'm using a SATA attached SSD (Samsung).

Attached is the Clover folder.

I'm leaving for a funeral so it will be a couple hours before I can respond. Thank you so much for trying to help me!

try adding lilu and whatevergreen kexts to clover/kexts/other

remove OsxAptioFix2Drv-64 from drivers64UEFI folder

 

[cmn699]

I'm using a SATA attached SSD (Samsung).

Attached is the Clover folder.

I'm leaving for a funeral so it will be a couple hours before I can respond. Thank you so much for trying to help me!

Try the edited Clover.zip; unzip and replace the one in the EFI partition and boot in Verbose and upload image(s) of any problem screen(s).

 

[EddyMac]

try adding lilu and whatevergreen kexts to clover/kexts/other

remove OsxAptioFix2Drv-64 from drivers64UEFI folder

OK I did those things and now it looks like it is finishing the Mojave install. Says it has 13 minutes left.

I'll update when there's something new to report.

 

[EddyMac]

The Mojave install finished. Audio, graphics, and network seem to be working fine without any further action needed.

Next I'm going to try following the FB-Patcher guide to get USB working. I did this on my build a few days ago and it worked great.

Thank you feartech and cmn699 for willingly giving your time to help me!

 

[EddyMac]

USB patching is all done and appears successful.

 

[Feartech]

USB patching is all done and appears successful.

nice

well done!

 

[EddyMac]

Thank you! And thanks again for your help!

 

[cmn699]

Thank you! And thanks again for your help!

May be you could change the TITLE of your post Prefixing [SUCCESS].
That way this will help others looking for answers for the same problem with the same or similar hardware.