- Joined
- Nov 29, 2014
- Messages
- 20
- Motherboard
- Asrock B450M Pro4
- CPU
- Ryzen 1600x
- Graphics
- RX 560
Hey, sadly no. With your aml file the IOReg Name changed to ethernet, but the card is still not showing up under network, kext isnt loadingHey Grasshopper, hope it works
sudo kextstat | grep AppleEthernetAquantiaAqtion
Executing: /usr/bin/kmutil showloaded
No variant specified, falling back to release
did 2 nvmram resets in opencore
yes, maybe that was to much, but i had to make a fresh install so i thaught why notChanging to AMD (hence the "exotic" ACPI paths) and trying Monterey may be too much change in one go…
"ETH0" or "ETH1" is not the issue: Any legal ACPI name would do, and _SB.PCI0.GPP2.PT02.PT24.ETH0 is not the same as ETH0 in another path. (You may try "ERSR" or any other mangling of "erasor2010" to four characters if you want )
Maybe a full copy of your IOReg could help understand what's going on?
[Guide] How to Make a Copy of IOReg
IORegistryExplorer aka IOReg Apple Developer Tool Xcode How to Make a Copy of IOReg (Note 1) 1. IORegistryExplorer/File/Save a Copy As…. (no extension required) 2. Open file to verify (Note 2) 3. Attach to post (Note 3) Where To Get IOReg 1. Download Interim, link below Installation 1, Open...www.tonymacx86.com
here is the complete ioreg