Contribute
Register

PowerMac G4 Cube

Status
Not open for further replies.
[video=youtube;t10pMSsb_Vc]https://www.youtube.com/watch?v=t10pMSsb_Vc[/video]
 
You sir - Inspirational! Amazing attention to detail! The milling and the custom LED sensor module you made, love it!

I was satisfied with my cube mod when i got the OEM switch to work with my DQ77KB, but you took it to another level by retaining the pulsating!

Thanks so much for sharing, i'll be looking into making a similar board for my power switch now :)

Also - I lol'd at "Dat heat retention" haha
 
Awesome, glad it was of some use! Do check out my Switch thread on this board; it covers the sensor documentation in a little more detail and I had uploaded a (now rather pointless) schematic for the PCB while exploring input types.

The more useful part to you will be the various ways of talking to the board. Since you have the Intel itx, you should be right to use the same method I did with the polarity checking. However if you choose to move to a different board later, there are additional topologies briefly covered for handling different cases.
 
Great advice :)
Will definitely look into it!

Aussies FTW!
Where abouts you from anyway? im in Sydney.
 
Brisbane
 
Status
Not open for further replies.
Copyright © 2010 - 2024 tonymacx86 LLC
Back
Top