No HDD detected at Installation in Disk Utility

[DGTech]

Hey guys

I got my Installation running but I can't select any drive in the Installation Disk Utility. It only Shows my USB.

I got a :
I7 6700k
Maximus VIII Hero
Corsair LPX 16GB
Club 3d hd7870
Samsung 850evo (Windows)
Seagate 500gb (the drive i want to use)

I was using this guide. http://www.tonymacx86.com/el-capita...ranger-i5-6600-gtx-970-clover-el-capitan.html

Pls help me. I already Set the SATA Controller to AHCI.

 

[DGTech]

Bumb

 

[DGTech]

No one who can help me ?

 

[julian200601]

Facing this as well on my Asus G20AJ:
Intel Core i7-4790 (Haswell) @ 3.6 ghz
Nvidia Geforce GTX 970 Reference
480gb Sandisk SSD
2TB Toshiba HDD
Intel H97 based Asus MB

Bios:
Secure boot @ Other OS
Sata controller @ AHCI
vt-d disabled

Clover lists all drives correctly but disk utility only shows the usb I boot from.

 

[julian200601]

Ok, so now I got at least this: On the Mac/Hackintosh you create the usb on, run multibeast and navigate to drivers -> disk and check all. then go to build and select the usb as target. Not sure if this helps you, but, now, booting, it fails because of missing bluetooth controller transport. My boot args include nv_disable=1...

 

[crunchyapple]

Hi - got the same problem with my SSD not being detected.

I tried installing the AHCI drivers to the Unibeast USB but it still didn't work... Perhaps putting the drivers inside the Other folder on the EFI partition of the USB might do it?