No Audio Devices - Realtek ALC AppleHDA [Guide]

[imacleopard]

That worked Toleda!!! Thanks so much!

To confirm for everyone's reference, my issue was that the AppleHDA.kext and my Yosemite OS version were not the same.

I updated OS to 10.10.2, restarted, reinstalled ALC898 with HDA Enabler =1 via Multibeast 7.2.2., restarted, and I have sound and all output options now showing..

I appreciate your help...

Mark

Just reporting in. Had the exact same issue with the same motherboard.

Z77X-UD5H.

Followed through with this case and all I had to do was install 10.10.2 combined and upon restart all my options and sound were back.

Thanks!

 

[petricherry0907]

1. my laptop doesn’t have sound, no audio devices were detected. codec id not showing in dpcimanager. audio is a ALC233
2. OS X version - 10.10 Yosemite
   1. laptop model - Lenovo Flex 2-14
   2. specs - Intel Core i5-4210u, Intel HD 4400
3. Procedure used: cloverALC
4. ioreg attached..
5. appleHDA.kext attached..
6. N/A
7. N/A
8. screenshots attached..
9. N/A
10. N/A
11. config.plist & debug.log attached..

Thanks you!..any help would be very much appreciated..-)

 

[toleda]

1. my laptop doesn’t have sound

Desktop Only

 

[selsiusx]

I have a problem. I followed everything in your guide and everything checks out.. I have all the corrects ids and codecs but no sound device detected. In the system information pane my audio device is visible.. only is system preferences it says 'No output devices found'

My system is a CLOVER boot yosemite 10.10.3 ALC892 and I have the kext-dev-mode=1 bootflag

van anybody help me (I also attached my config.plist)?

method : realTekALC (no script output it said succesfull)
I cannot find sound assertions in my console log

 

[toleda]

I have a problem. I followed everything in your guide and everything checks out.

Attach all requested files, Problem Reporting, Post #1.

 

[selsiusx]

Attach all requested files, Problem Reporting, Post #1.

added to original post

 

[iBert]

I see 4 ¡output hdmi¡, but I have not audio with realtek 1150. No audio and no audi devices.

I dont kwow what can I do.

 

[toleda]

I followed everything in your guide and everything checks out.

Appears 3 different methods are installed;each method works on its own, all methods fail when combined.
Remove S/L/E/AppleHDA892.kext and restart.
Reply with new IOReg.

 

[toleda]

I see 4 ¡output hdmi¡

Remove Voodoo. Clean install is likely.

 

[mrwat]

I started following the instructions in the first post, but after I added kext-dev-mode=1 my audio output devices showed up. Is this just a result of enabling a debugger of some sort and should I continue troubleshooting to figure out what the issue really is?

My motherboard is GIGABYTE GA-Z97X-UD3H
Audio is ALC1150

Thanks