I'm putting snow leopard with the cd I follow all the steps and I can'T get my system to boot right and the graphic card is not working properly.
is I7 core 2600k
motherboard is an asus P8Z68-V
CHIP SET Z68
CPU LGU1155
16 GB OS COARSIRE RAM
AND GPU IS A ASUS GTX 560 DIRECT CUII OC WITH 1GB
CAN SOME ONE HELP ME PLS
redwwolf
Suspect that video card... can you remove it for now....
You need to setup the motherboard for internal GFX w the HD3000 of the CPU.
THis means you need to set the video BIOS to internal video and limit the ram to 64 megs.
This motherboard has been used in the past and should work
Here is a anotized install method.
-------------------------------------------------------------------
How to do a sandy bridge cpu w compatible hardware OSX hack 10.6.8 build. jester969
Typical installation steps are:
1) iBoot + Disk Utility + install Snow Leopard DVD (perform install via DVD) reboot
2) iBoot + Installed OSX HDD (boot with iBoot and loading OS via newly installed HDD) - get welcome screen
3) Run
Update Helper and Reboot?
4) iBoot + Installed OSX HDD, run combo update 10.6.8 , DO NOT reboot
5) Run Multibeast and select option which are required to your board
and run System Utilities.
6) Reboot w/out iBoot
Audio/Ethernet/DSDT
DSDT and BIOS firmware must match to the corresponding number.
Search forms for installs w that motherboard and SL.
You may need to use a DSDT or make locate one!
Se our DSDT section in the forum.
DO NOT USE THE VIDEO CARD only HD3000 for now.
