Multibeast GA-Z87X-UD5H and Mavericks

[Cionny]

Hi guys, i'm Italian and sorry if my english isn't the best.

This is my configuration:
Motherboard: Gygabyte GA-Z87X-UD5H
CPU: i7-4770k
Ram: Crucial Ballistix Tactical Tracer 1600 8GB (1x)
No graphic card
SSD: Samsung 840 Series Pro 256GB
HD: Seagate Barracuda ST1000DM003 1TB
Power Supply: Corsair RM650
Case: Corsair 500R

Additional info:
OSX 10.9.4
I use the DVI, not the HDMI.
The router is connected in Ethernet.

I followed this guide: http://www.tonymacx86.com/374-unibeast-install-os-x-mavericks-any-supported-intel-based-pc.html

I've three question:

1. "If using a Socket 1156 system without Rate Matching Hub (RMH) USB choose Legacy USB Support".
I've choosen Legacy USB Support. It's correct? I tried to install without choosing it before, but it gave me an error during the installation, so i've installed the "version" with the Legacy USB Support, and it seems working.

2. I've to change anything in the BIOS? (I've set to Optimized Defaults, and the VT-d was already disabled)

3. What I've to install with Multibeast?

Thanks a lot!

 

[Cionny]

No one?

 

[Cionny]

Up

 

[leonvmetcalf]

Does your motherboard use UEFI? If so, choose DDST free. And the Legacy USB Support feature is only for Socket 1156 while your motherboard and CPU are Socket 1150 so you should have that feature disabled for stability. And since you are not using a dedicated GPU, use:

IGPEnabler=Yes

to enable Intel HD Graphics.

Of course, continue to follow Tonymac's guide for the BIOS settings including to change the hard drive type to AHCI in the settings.