- Joined
- Mar 13, 2016
- Messages
- 11
- Motherboard
- ASRock H97M Anniversary
- CPU
- i5-4590
- Graphics
- GTX 970
- Mac
Hi there,
I'm new to building my own costume Mac. After following the installation guide for 10.11(.3) I went through the hole installation process without any trouble. Now I got stuck in the post installation process. Using MultiBeast (8.1) I tried to get my audio and WiFi card to work.
I researched the specs of my parts trying to find the right options to install - which was not very successful. But I found the Audio codec of my main board. After installing the kext the in & output devices are still not available in the system preferences. Furthermore changing the system definition has no effect (at least no visible like in 'about this mac ...').
Is this behavior normal? And how can I get my system to work?
----------
main board:
ASRock H97M (Anniversary)
WiFi module:
TL-WN781ND (v2.2)
I'm new to building my own costume Mac. After following the installation guide for 10.11(.3) I went through the hole installation process without any trouble. Now I got stuck in the post installation process. Using MultiBeast (8.1) I tried to get my audio and WiFi card to work.
I researched the specs of my parts trying to find the right options to install - which was not very successful. But I found the Audio codec of my main board. After installing the kext the in & output devices are still not available in the system preferences. Furthermore changing the system definition has no effect (at least no visible like in 'about this mac ...').
Is this behavior normal? And how can I get my system to work?
----------
main board:
ASRock H97M (Anniversary)
WiFi module:
TL-WN781ND (v2.2)